Skip to main content
FlashGrid.io

Updating FlashGrid software RPMs (On-Premises Only)

  • Updated
  • Products: FlashGrid Storage Fabric

Note: Please review the corresponding release notes and check with FlashGrid support before performing any major version update. A major version consists of the first two numbers. The third number represents a revision (hotfix). For example, an update from version 19.02.x to 19.05.x is major, but from 19.05.100 to 19.05.200 is a hotfix revision.

Note: Simultaneously updating FlashGrid software and applying Grid Infrastructure patches in a rolling fashion is not recommended. FlashGrid services should not be stopped while the GI cluster is in rolling patching mode.

Updating FlashGrid SF and CLAN

To update flashgrid-sf and/or flashgrid-clan RPMs on a running cluster, repeat the following steps on each node, one node at a time

  1. Make sure there are no other nodes that are in an offline or re-syncing state. All disk groups must have zero offline disks, and Resync = No:

    # flashgrid-cluster

  2. If the node is a database node,

    a. Stop all local database instances running on the node.

    b. Stop Oracle CRS:

    # crsctl stop crs

  3. Stop the FlashGrid Storage Fabric services:

    # flashgrid-node stop

  4. Stop the FlashGrid Cloud Area Network service, if installed:

    # systemctl stop flashgrid-clan
  5. Update the flashgrid-sf and flashgrid-clan (if installed) RPMs using yum or rpm tool.
  6. Run sudo flashgrid-clan-cfg deploy-config-local after updating flashgrid-clan RPM.

  7. Reboot the node:

    # sync; sync
# reboot

  8. Wait until all disks are back online and resyncing operations are complete on all disk groups before updating the next node. All disk groups must have zero offline disks, and Resync = No.

    # flashgrid-cluster

Updating FlashGrid Diags

To update the flashgrid-diags RPM on a node, follow these steps.

  1. Update the flashgrid-diags RPMs using the yum or rpm tool.

  2. Restart the flashgrid-node-monitor service:

    # systemctl restart flashgrid-node-monitor

Updating FlashGrid Health Check

To update the flashgrid-health-check RPM on a node, follow these steps.

  1. Update the flashgrid-health-check RPMs using the yum or rpm tool.

  2. Restart the flashgrid-health-check service:

    # systemctl restart flashgrid-health-check